Steelite Pressure Washers Recall (August 2026)
Serious Injury or Death from Shock and Electrocution hazard — about 128 units.
| What | Steelite Pressure Washers |
|---|---|
| How many | About 128 units |
| The hazard | The recalled pressure washers lack an integral ground-fault circuit-interrupter (GFCI) and an adequate-length power cord, posing a risk of serious injury or death from shock and electrocution hazards. |
| Remedy | Consumers should stop using the recalled pressure washers immediately and contact Longer 3D for a full refund. Consumers will be asked to destroy the power washer by cutting the unplugged power cord in half and send a photo of the destroyed pressure washer to [email protected]. Consumers should then dispose of the destroyed recalled product. |
| Contact | Longer 3D by email at [email protected]. |
| Recall date | 2026-08-27 (recall no. 26723) |
What was recalled
This recall involves Steelite-branded pressure washers. They are red and black and measure about 30 inches high, 10 inches wide and 12 inches deep. The 2.5 gpm, electric pressure washers have a foam cannon, four quick connect nozzles and a 20-foot hose. Model “AZ6041VC” is printed on a label on the back of the pressure washer.
What to do
Stop using the product. The listed remedy is: Consumers should stop using the recalled pressure washers immediately and contact Longer 3D for a full refund. Consumers will be asked to destroy the power washer by cutting the unplugged power cord in half and send a photo of the destroyed pressure washer to [email protected]. Consumers should then dispose of the destroyed recalled product.. Longer 3D by email at [email protected].
Source: the official CPSC recall notice, published 2026-08-27. Every fact on this page comes from that notice — if anything here disagrees with it, the notice wins.